Home Topics Hexiwear stuck in Maintenance mode

Overview Forums Firmware and libraries Hexiwear stuck in Maintenance mode

This topic contains 2 replies, has 2 voices, and was last updated by  Uros Cvetinovic 2 years ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #3033


    I have managed to wipe out the default program on the HexiWear device and the docking station, the USB still works, but it reads as “MAINTENANCE” drive. Is there a link to the Daplink .hex file for the Hexiwear docking station so I can reinstall the firmware? The link “HELP_FAQ.HTM” on the MAINTENANCE drive points to 0234_microbit_if.hex, which doesn’t work.

    I have the same problem after only one download – stuck in MAINTENANCE mode and cannot find any instructions and/or files that work anywhere even using the Mikroprog software. Docking station does not show up as a serial port in Windows anymore.




    Uros Cvetinovic


    Please check troubleshooting section in this document:

    Tell if you had any luck with this.

    Best regards,


Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.