Home Topics Docking station and wifi3 demo

This topic contains 1 reply, has 2 voices, and was last updated by  Uros Cvetinovic 2 years, 12 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #2114


    I have connected a docking station to my Hexiwear, and connected the click3 wifi shield and click relay into sockets one and two respectively. I then load the project given as HEXIWEAR_Wifi_3_Click into mikroC Pro for ARM, compile and then run it.

    However it hangs up on “Resetting module” which is inside WiFI_Configure(). Has anyone encountered this before?

    edit: spelling

    • This topic was modified 3 years ago by  slashy42.

    Uros Cvetinovic


    Can you please try changing UART’s baud-rate to 9600, and tell me the result?

    Best regards,


Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.